It seems to make no difference whether or not the probe is connected. I even tried transferring the UF2 binary via the usb drive mount + picotool method, and detected no difference that way either.
I don't have a plain Pico, but I do have some Adafruit boards with RP2040 on (the feather and the QTPy). I suppose I could try it on those.
Also I should note that I am using a slightly different Adafruit SSD1306 board. It is made to be mounted directly onto a RPi's GPIO pins, but I just stuck jumper wires into the 3.3v, GND, SDA, and SCL slots and connected them to the appropriate pins on the Pico W.
I don't have a plain Pico, but I do have some Adafruit boards with RP2040 on (the feather and the QTPy). I suppose I could try it on those.
Also I should note that I am using a slightly different Adafruit SSD1306 board. It is made to be mounted directly onto a RPi's GPIO pins, but I just stuck jumper wires into the 3.3v, GND, SDA, and SCL slots and connected them to the appropriate pins on the Pico W.
Statistics: Posted by inklesspen — Mon Aug 12, 2024 7:10 pm